71M6531D_10 Datasheet, PDF (66/120 Pages) Teridian Semiconductor Corporation – Energy Meter IC

Data Sheet 71M6531D/F-71M6532D/F
FDS 6531/6532 005
3.5 Connecting LCDs
The 71M6531D/F and 71M6532D/F have an on-chip LCD controller capable of controlling static or
multiplexed LCDs. Figure 32 shows the basic connection for an LCD.
The following dedicated and multi-use pins can be assigned as LCD segment pins for the 71M6531D/F:
• 12 dedicated LCD segment pins: SEG0 to SEG2, SEG7, SEG8, SEG12 to SEG18.
• 7 dual-function pins: SEG3/PCLK, SEG4/PSDO, SEG5/PCSZ, SEG6/PSDI, E_RXTX/SEG9,
E_TCLK/SEG10, and E_RST/SEG11.
• 14 combined DIO and segment pins: SEG24/DIO4 to SEG35/DIO15, SEG37/DIO17, SEG48/DIO28,
SEG49/DIO29 and SEG63/DIO43 to SEG66/DIO46.
The following dedicated and multi-use pins can be assigned as LCD segments for the 71M6532D/F:
• 15 dedicated LCD segment pins: SEG0 to SEG2, SEG8, SEG12 - SEG18, SEG20 - SEG23.
• 9 dual-function pins: MUX_SYNC/SEG7, E_RXTX/SEG9, E_TCLK/SEG10, E_RST/SEG11,
SEG3/PCLK, SEG4/PSDO, SEG5/PCSZ, SEG6/PSDI.
• 43 combined DIO and segment pins, as described in section 1.5.8.
71M6531D/F or 71M6532D/F
LCD
segments
commons
.
Figure 32: Connecting LCDs
3.6 Connecting I²C EEPROMs
I²C EEPROMs or other I²C compatible devices should be connected to the DIO pins DIO4 and DIO5, as
shown in Figure 33.
Pull-up resistors of roughly 10 kΩ to V3P3D (to ensure operation in BROWNOUT mode) should be used
for both SCL and SDA signals. The DIO_EEX[1:0] register in I/O RAM must be set to 01 in order to convert
the DIO pins DIO4 and DIO5 to I²C pins SCL and SDA.
71M6531D/F
71M6532D/F 10 kΩ
DIO4
DIO5
V3P3D
10 kΩ
EEPROM
SCL
SDA
Figure 33: I²C EEPROM Connection
66
© 2005-2010 TERIDIAN Semiconductor Corporation
v1.3