408-8788 Datasheet, PDF (7/13 Pages) TE Connectivity Ltd – EBC-440 46-Way

Unmating
1 ^{Depress the cam lever lock.}
NOTE
i
When depressing the cam lever lock, the
cam lever should move slightly toward the
shipping position (unmated). If it does not,
pull the cam lever back past the lock, then
depress the cam lever lock.
Rotate
Cam Lever
Depress
Cam Lever Lock
Cam Lever
Stop
408-8788
2 Rotate the cam lever until it butts against
the cam lever stop.
NOTE
i
The connector will remain attached to the
module by means of the pre-latch feature.
Cam Lever
Against Cam
Lever Stop
3 Grasp the connector at the sides and,
while gently rocking the connector from
side-to-side, pull the connector straight
from the module until the pre-latch
feature disengages from the module
cam lobe.
DO NOT Twist Connector
During Unmating
Pull Connector Straight
Rock Connector
from Side-to-Side
Pre-Latch Feature
Disengaged from
Module Cam Lobe
Rev D
Module Released
from Connector
CAUTION
To avoid damage to the wires or connector,
DO NOT use the wire bundle as a handle
to pull the connector from the module.
!
7 of 13