408-8788 Datasheet, PDF (3/13 Pages) TE Connectivity Ltd – EBC-440 46-Way

Terminal Insertion Continued -
Cavities 2 and 16
6.3mm Terminals
Stabilizer Tabs
Facing Inward
Toward Centerline
of Connector
Cavities 31 and 45
408-8788
Cavities 3 Through 15
0.64mm Terminals
Cavities 18 Through 29
Stabilizer Tabs
Facing Inward
Toward Centerline
of Connector
Cavities 32 Through 44
Retention Window Facing Outward
Toward Long Edge of Connector
Retention Window Facing Inward
Toward Centerline of Connector
Retention Window Facing Outward
Toward Long Edge of Connector
3 Insert the terminal into the circuit cavity
until there is an audible “click.” Lightly pull
the wire to ensure that the terminal is
locked into place.
Apply Even Pressure to Full Surface of TPA
When Pushing TPA Into Housing
4
After all desired terminals are inserted,
push each end of the TPA into the housing
until it is flush with the housing.
If there is resistance while pushing the
TPA, make sure that every terminal is fully
inserted.
5 Using tape or similar material, wrap the
wires together to form a bundle.
CAUTION
DO NOT apply extra pressure to the
outside edges of the TPA; otherwise,
the TPA could break.
!
Rev D
3 of 13