408-8788 Datasheet, PDF (6/13 Pages) TE Connectivity Ltd – EBC-440 46-Way

Wire Cover Removal
1 ^{Depress the cam lever lock.}
NOTE
i
When depressing the cam lever lock, the
cam lever should move slightly toward the
shipping position (unmated). If it does not,
pull the cam lever back past the lock, then
depress the cam lever lock.
Rotate
Cam Lever
Depress
Cam Lever Lock
Cam Lever
Stop
408-8788
2 Rotate the cam lever until it butts against
the cam lever stop.
NOTE
i
The connector will remain attached to the
module by means of the pre-latch feature.
Cam Lever
Against Cam
Lever Stop
3 Insert the tip of a small flat blade
screwdriver, or similar tool, into each of
the retention tabs on one side of the
wire cover, and pry the side of the wire
cover away from the connector.
Repeat this for the other side of the
wire cover.
4 Lift the wire cover straight off of the
connector.
Retention Tab
(2 Places, Each side
of Wire cover)
Tip of Screwdriver
(Ref)
Rev D
6 of 13