408-8788 Datasheet, PDF (11/13 Pages) TE Connectivity Ltd – EBC-440 46-Way

408-8788
Cam Lever Replacement Continued -
4 Hold the connector so that the wire exit end
faces down, and gently tap the back of the
connector until both slide blocks align with
the body of the connector.
Back of Connector
5 Holding the new cam lever horizontal to the
connector, slide it over the back of the
connector. Make sure that the curved edge of
the arms face the curved slot of the connector.
Back of Connector
Body of Connector
Wire Exit
Curved Edge
of Arm
Curved Slot of
Connector
Slide Blocks
For proper placement, the first lobe of the
cam lever must align with the first lobe of
the slide block.
First Lobe of
Cam Lever
First Lobe of
Slide Block
CAUTION
!
To avoid damage to the peripheral seal,
DO NOT insert any device into the back
of the connector to force the slide blocks
into position.
Cam Lever Shown
Turned to Show Lobes
Rev D
Continued -
11 of 13