D-6021 Datasheet, PDF (5/14 Pages) TE Connectivity Ltd – Multiplex DataBus Box Couplers and Terminators Connectorized with D-6025 Connector Interface

MIL-STD-1553B Multiplex DataBus Box Couplers and
Terminators Connectorized with D-6025 Connector
Interface
D-6021
Revision A1
25-Mar-15
3.6.1.6 Terminator Resistance Test
When a terminator is tested as specified in 4.5.3.5, the measured DC
resistance of the resistor shall meet the requirements of the applicable
specification control drawing.
3.6.1.7 Transmission Test
When box couplers and terminators are tested as specified in 4.5.3.6,
there shall be no word errors detected during functional operation.
3.6.2 Insulation Resistance
When specimens are tested as specified in 4.5.4, the insulation resistance between
each conductor and the enclosure shall be 100 megohms minimum.
3.6.3 Dielectric Strength
When specimens are tested as specified in 4.5.5, there shall be no arcing or
breakdown between each conductor and the enclosure. The leakage current shall
be 2 milliamperes maximum.
3.6.4 Temperature Shock
When tested as specified in 4.5.6, specimens shall function normally during the
test, and there shall be no evidence of damage detrimental to performance.
3.6.5 Temperature Altitude
When tested as specified in 4.5.7, specimens shall function normally during the
test, and there shall be no evidence of damage detrimental to performance.
3.6.6 Altitude Immersion*
When tested as specified in 4.5.8, specimens shall meet the insulation resistance
requirement of 3.6.2, and there shall be no evidence of damage detrimental to
performance.
3.6.7 Moisture Resistance*
When tested as specified in 4.5.9, specimens shall meet the insulation resistance
requirement of 3.6.2, and there shall be no evidence of damage detrimental to
performance.
© 2015 Tyco Electronics Corporation, a TE Connectivity Ltd. Company. All Rights Reserved. TE Proprietary & Confidential Information.
If this document is printed, it becomes uncontrolled. Check for latest revision.
Page 5 of 14