D-6021 Datasheet, PDF (3/14 Pages) TE Connectivity Ltd – Multiplex DataBus Box Couplers and Terminators Connectorized with D-6025 Connector Interface

MIL-STD-1553B Multiplex DataBus Box Couplers and
Terminators Connectorized with D-6025 Connector
Interface
D-6021
Revision A1
25-Mar-15
3.0 Requirements
3.1 Specification Control Drawings
The requirements for individual items under this specification shall be as specified
herein and in the applicable specification control drawing. In the event of conflict between
the requirements of this specification and those of the specification control drawing (SCD),
the latter shall govern.
3.2 Classification of Requirements
The requirements for these products are classified herein as follows:
Requirement
Qualification
Materials
Design and
Construction
Performance
Identification
Workmanship
Paragraph
3.3
3.4
3.5
3.6
3.7
3.8
3.3 Qualification
Items furnished under this specification or listed on Qualified Products List D-6021-QPL
shall be products that are qualified to this specification.
3.4 Materials Requirements
All materials used in the manufacture of these products shall be of the quality and form
best suited for the purpose intended. All materials used shall conform to the requirements
specified herein.
3.4.1 Dissimilar Metals
When dissimilar metals are used in intimate contact with each other, protection
against electrolytic corrosion shall be provided as specified in MIL-STD-454,
Requirement 16.
3.4.2 Component Materials
Materials for specific components of these items shall be as follows:
a. Isolation transformer--Per MIL-STD-1553B and MIL-T-21038
b. Resistors--Per MIL-STD-1553B, and MIL-R-55182 or MIL-R-39007
c. Box coupler housing--Aluminum alloy
d. Terminator housing--Stainless steel
e. Solder--QQ-S-571
© 2015 Tyco Electronics Corporation, a TE Connectivity Ltd. Company. All Rights Reserved. TE Proprietary & Confidential Information.
If this document is printed, it becomes uncontrolled. Check for latest revision.
Page 3 of 14