D-6021 Datasheet, PDF (1/14 Pages) TE Connectivity Ltd – Multiplex DataBus Box Couplers and Terminators Connectorized with D-6025 Connector Interface

MIL-STD-1553B Multiplex DataBus Box Couplers and
Terminators Connectorized with D-6025 Connector
Interface
D-6021
Revision A1
25-Mar-15
1.0 Introduction
1.1 Scope
This specification covers the Raychem D-500-0255 series of MIL-STD-1553B multiplex
data bus box couplers and D-621-XXXX series of MIL-STD- 1553B terminators.
1.2 Description
Items covered by this specification are non-repairable components installed as parts of a
data bus system. They provide intrinsic EMI shielding.
1.3 Classification
These items are classified (solely dependent upon the connector interface type and
environmental resistance) as follows:
a Connector Type: Threaded connector type
Bayonet connector type
b Environmental Resistance of Connector:
General purpose (terminators only)
Environment resistant
Environment resistant, 1000 hour salt spray
1.4 Intended Use
Data bus box couplers covered by this specification provide fault isolation by series
resistance and transformer coupling between the bus cables and stub cables in
accordance with MIL-STD-1553B. Data bus terminators covered by this specification
provide matched impedance bus termination or stub termination with a resistive load
simulating a remote terminal (RT). These products may be used in applications within the
operating temperature range of -55°C to +125°C.
2.0 Applicable Documents
2.1 Issues of Documents
The following documents, of the issue in effect on date of order or request for proposal,
form a part of this specification to the extent specified herein. However, this specification
takes precedence over the referenced documents.
© 2015 Tyco Electronics Corporation, a TE Connectivity Ltd. Company. All Rights Reserved. TE Proprietary & Confidential Information.
If this document is printed, it becomes uncontrolled. Check for latest revision.
Page 1 of 14