D-6021 Datasheet, PDF (11/14 Pages) TE Connectivity Ltd – Multiplex DataBus Box Couplers and Terminators Connectorized with D-6025 Connector Interface

MIL-STD-1553B Multiplex DataBus Box Couplers and
Terminators Connectorized with D-6025 Connector
Interface
D-6021
Revision A1
25-Mar-15
Figure 2. Module Voltage Tests
Figure 3. Box Coupler Voltage Tests
4.5.3.4 Box Coupler Minimum Voltage Test (see 3.6.1.5). Box couplers shall be
tested using the test configurations shown in Figures 2 and 3,
respectively. The minimum terminal output voltage of 18 V p-p shall be
applied at V1 using the 250 kHz waveform described in 4.5.3.2. The
output voltage shall be measured at V2. This test shall then be repeated
using a 1 MHz waveform described in 4.5.3.2.
4.5.3.5 Terminator Resistance Test (see 3.6.1.6). The DC resistance of the
terminator shall be measured in accordance with MIL-STD-202, Method
303.
4.5.3.6 Transmission Test (see 3.6.1.7). MIL-STD-1553B words shall be
transmitted over a network composed of box couplers and terminators
interconnected with suitable data bus cable. The transmitter output shall
be 18 V p-p with a 300-nanosecond rise time. A special terminal equipped
© 2015 Tyco Electronics Corporation, a TE Connectivity Ltd. Company. All Rights Reserved. TE Proprietary & Confidential Information.
If this document is printed, it becomes uncontrolled. Check for latest revision.
Page 11 of 14