D-6021 Datasheet, PDF (12/14 Pages) TE Connectivity Ltd – Multiplex DataBus Box Couplers and Terminators Connectorized with D-6025 Connector Interface

MIL-STD-1553B Multiplex DataBus Box Couplers and
Terminators Connectorized with D-6025 Connector
Interface
D-6021
Revision A1
25-Mar-15
with counters shall be used to count the number of correct words and error
words received during the test.
4.5.4 Insulation Resistance (see 3.6.2). Specimens shall be tested in accordance with
MIL-STD-202, Method 302, Test Condition B (500 Vdc). Insulation resistance shall
be measured between each conductor and shield of attached cables.
4.5.5
Dielectric Strength (see 3.6.3). Specimens shall be tested in accordance with
MIL-STD-202, Method 301, using 500 Vac, 60 Hz. The test voltage shall be applied
for I minute between each conductor and shield of attached cables. Leakage
current shall be recorded.
4.5.6
Temperature Shock (see 3.6.4). Specimens shall be tested in accordance with
MIL-STD-202, Method 107, Test Condition B, except that the low temperature shall
be -55*C, the dwell time shall be 4 hours and the number of cycles 3. During this
test, the specimens shall be subjected to the transmission test of 4.5.3.6.
4.5.7 Temperature-Altitude (see 3.6.5). Specimens shall be exposed to the temperature-
altitude conditions shown in Table III. During this test, except for Step 1, the
specimens shall be subjected to the transmission test of 4.5.3.6.
Table III. Temperature Altitude Conditioning
Step
Temperature
(°C)
1
-65
2
-54
3
-54
4
-10
5
95
6
71
7
95
8
36
9
60
10
10
11
35
Altitude
(ft)
Site
Site
70,000
Site
Site
Site
Site
50, 000
50, 000
70,000
70,000
Duration
(hrs)
2.0
*
*
*
16.0
4.0
0.5
4.0
0.5
4.0
0.5
* Duration sufficient to allow temperature stabilization
© 2015 Tyco Electronics Corporation, a TE Connectivity Ltd. Company. All Rights Reserved. TE Proprietary & Confidential Information.
If this document is printed, it becomes uncontrolled. Check for latest revision.
Page 12 of 14