SI53106 Datasheet, PDF (27/34 Pages) Silicon Laboratories – SIX-OUTPUT PCIE GEN 3 BUFFER/ZERO DELAY BUFFER

Si53106
Table 25. Si53106 40-Pin QFN Descriptions
Pin #
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
Name
Type
Description
100M_133M
HBW_BYPASS_LBW
PWRGD/PWRDN
I,SE 3.3 V tolerant inputs for input/output frequency selection. An external pull-
up or pull-down resistor is attached to this pin to select the input/output
frequency.
High = 100 MHz output
Low = 133 MHz output
I, SE
Tri-Level input for selecting the PLL bandwidth or bypass mode.
High = High BW mode
Med = Bypass mode
Low = Low BW mode
I 3.3 V LVTTL input to power up or power down the device.
VDDR
CLK_IN
VDD 3.3 V power supply for differential input receiver. This VDDR should be
treated as an analog power rail and filtered appropriately.
I, DIF 0.7 V Differential input.
CLK_IN
I, DIF 0.7 V Differential input.
SA_0
I,PU 3.3 V LVTTL input selecting the address. Tri-level input.
SDA
I/O Open collector SMBus data.
SCL
I/O SMBus slave clock input.
SA_1
I,PU 3.3 V LVTTL input selecting the address. Tri-level input.
NC
I/O No connect. There are active signals on pin 11and 12, do not connect
anything to these pins.
NC
I/O No connect. There are active signals on pin 11 and 12, do not connect
anything to these pins.
NC
- Do not connect this pin to anything.
OE_0
DIF_0
I, SE 3.3 V LVTTL active low input for enabling differential outputs (default).
Controls the corresponding output pair. Internal pull-down.
O, DIF 0.7 V Differential clock output. Default is 1:1.
DIF_0
O, DIF 0.7 V Differential clock output. Default is 1:1.
VDD
3.3 V 3.3 V power supply for outputs.
DIF_1
O, DIF 0.7 V Differential clock output. Default is 1:1.
DIF_1
O, DIF 0.7 V Differential clock output. Default is 1:1.
OE_1
VDD_IO
I, SE 3.3 V LVTTL active low input for enabling differential outputs (default).
Controls the corresponding output pair. Internal pull-down.
VDD Power supply for differential outputs.
OE_2
DIF_2
I, SE 3.3 V LVTTL active low input for enabling differential outputs (default).
Controls the corresponding output pair. Internal pull-down.
O, DIF 0.7 V Differential clock outputs. Default is 1:1.
Rev. 1.2
27