SAB88C166 Datasheet, PDF (31/58 Pages) Siemens Semiconductor Group – 16-Bit CMOS Single-Chip Microcontrollers with/without oscillator prescaler with 32 KByte Flash EPROM

SAB 88C166(W)
Parameter
Power-down mode supply current
V_PP read current
V_PP writing current
Symbol
Limit Values
min.
max.
I_PD
–
50
I_PPR
–
200
I_PPW
–
50
V_PP during write/read
V_PP
11.4
12.6
Unit Test Condition
µA V_CC = 5.5 V ⁷⁾
µA V_PP > V_CC
mA 1/TCL = 40 MHz
32-bit
programming
V_PP = 12 V
V
Notes
1) _{This specification does not apply to the analog input (Port 5.x) which is currently converted.}
2) _{The maximum current may be drawn while the respective signal line remains inactive.}
3) _{The minimum current must be drawn in order to drive the respective signal line active.}
4) _{This specification is only valid during Reset, or during Hold-mode.}
5) _{Not 100% tested, guaranteed by design characterization.}
6) _{The supply current is a function of the operating frequency. This dependency is illustrated in the figure below.}
These parameters are tested at V_CCmax and 20 MHz CPU clock with all outputs disconnected and all inputs at
V_IL or V_IH.
7) _{All inputs (including pins configured as inputs) at 0 V to 0.1 V or at VCC – 0.1 V to VCC, VREF = 0 V, all outputs}
(including pins configured as outputs) disconnected.
A voltage of V_CC ≥ 2.5 V is sufficient to retain the content of the internal RAM during power down mode.
Semiconductor Group
30