7480 Datasheet, PDF (96/98 Pages) Bi technologies – 7/8 Diameter 5-Turn Wirewound Precision Potentiometer

PRELIMINARY _{NSootimcee: pTahriasmisentroict} ^{alimfinitsalasrpeescuifbicjeactitotno. change.}
MITSUBISHI MICROCOMPUTERS
7480/7481 GROUP
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
44P6N (44-PIN QFP) MARK SPECIFICATION FORM
Mitsubishi IC catalog name
Please choose one of the marking types below (A, B, C), and enter the Mitsubishi IC catalog name and the special
mark (if needed).
A. Standard Mitsubishi Mark
#3
@3
#4
@2
Mitsubishi lot
number (6-digit)
Mitsubishi IC catalog name
$4
!2
q
!1
B. Customer’s Parts Number + Mitsubishi Catalog Name
#3
@3
Customer’s parts number
#4
@2 ^{Note : The fonts and size of characters are standard}
Mitsubishi type.
Mitsubishi IC catalog name and Mitsubishi lot number
Note4 : If the Mitsubishi logo is not required, check
the box below.
$4
!2
Mitsubishi logo is not required.
q
!1
Note1 : The mark field should be written right aligned.
2 : The fonts and size of characters are standard
Mitsubishi type.
3 : Customer’s parts number can be up to 7 characters :
,Only 0 ~ 9, A ~ Z,+,–, ⁄ , (, ), &, ©, • (period), and
(comma) are usable.
C. Special Mark Required
#3
@3
#4
@2
$4
!2
Note1 : If the special mark is to be printed, indicate the
desired layout of the mark in the left figure. The
layout will be duplicated as close as possible.
Mitsubishi lot number (6-digit ) and mask ROM
number (3-digit) are always marked.
2 : If the customer’s trade mark logo must be used
in the special mark, check the box below.
Please submit a clean original of the logo.
For the new special character fonts a clean
font original (ideally logo drawing) must be sub-
mitted.
Special logo required
q
!1
3 : The standard Mitsubishi font is used for all characters ex-
cept for a logo.
95