HD64F3687GFPV Datasheet, PDF (92/538 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 3 Exception Handling
WKP5 to WKP0 Interrupts
WKP5 to WKP0 interrupts are requested by input signals to pins WKP5 to WKP0. These six
interrupts have the same vector addresses, and are detected individually by either rising edge
sensing or falling edge sensing, depending on the settings of bits WPEG5 to WPEG0 in
IEGR2.
When pins WKP5 to WKP0 are designated for interrupt input in PMR5 and the designated
signal edge is input, the corresponding bit in IWPR is set to 1, requesting the CPU of an
interrupt. These interrupts can be masked by setting bit IENWP in IENR1.
RES
Reset cleared
Initial program
Vector fetch Internal ^{instruction prefetch}
processing
φ
Internal
address bus
Internal read
signal
Internal write
signal
Internal data
bus (16 bits)
(1)
(2)
(2)
(3)
(1) Reset exception handling vector address (H'0000)
(2) Program start address
(3) Initial program instruction
Figure 3.1 Reset Sequence
Rev.5.00 Nov. 02, 2005 Page 58 of 500
REJ09B0027-0500