HB28K032MM3 Datasheet, PDF (80/91 Pages) Renesas Technology Corp – MultiMediaCard 32 MByte/64 MByte/128 MByte/256 MByte/512 MByte

HB28K032/L064/J128/J256/J512MM3, HB28K032/L064/J128/J256RM3
Absolute Maximum Ratings
Absolute maximum ratings are those values beyond which damage to the device may occur. Functional
operation under these conditions or at any other condition beyond those indicated in the operational
sections of this specification is not implied:
Parameter
Supply voltage
Total power dissipation
ESD
Contact Pads
protection
Inputs
Outputs
Non Contact Pads
coupling plane discharge
Non Contact Pads
air discharge
Input voltage
Output voltage
High-level output current
Low-level output current
Symbol Min
V_CC
−0.5
P_d

−4
Max
4.6
288
4
−8
8
−15 15
Unit Remark
V
mW
kV Human body model
according to ANSI/EOS
ESD-S5.1-1998
kV Human body model
according to IEC61000-4-2
kV
V
Imax
V_Omax
I_OHmax
I_OLmax
−0.5
−0.5
−100

V + 0.5 V
CC
V_CC + 0.5 V

mA
150
mA
≤
max
(V )
CC
≤ max (V_CC)
Short cut protected
Short cut protected
Bus Signal Line Load
The total capacitance C_L of each line of the MultiMediaCard bus is the sum of the bus master capacitance
C_HOST, the bus capacitance C_BUS itself and the capacitance C_CARD of each card connected to this line:
= + + C
L
C
HOST
C
BUS
N
*
C
CARD
where N is the number of connected cards. Requiring the sum of the host and bus capacitance’s not to
exceed 30 pF for up to 10 cards, and 40 pF for up to 30 cards, the following values must not be exceeded:
Parameter
Symbol
Min
Max
Unit
Remark
Pull-up resistance for CMD
R_CMD
Pull-up resistance for DAT
R_DAT
Bus signal line capacitance
C_L
4.7
100
kΩ
to prevent bus floating
50
100
kΩ
to prevent bus floating

250
pF
f_PP ≤ 5 MHz,
30 cards
Bus signal line capacitance
C_L

100
pF
f_PP ≤ 20 MHz,
10 cards
Maximum signal line inductance

16
nH
f
PP
≤
20
MHz
Note: 1. The value of pull-up resistance should be optimized according to the host system.
Rev.0.02, Sep.15.2004, page 80 of 89