|
HB28K032MM3 Datasheet, PDF (64/91 Pages) Renesas Technology Corp – MultiMediaCard 32 MByte/64 MByte/128 MByte/256 MByte/512 MByte | |||
|
◁ |
HB28K032/L064/J128/J256/J512MM3, HB28K032/L064/J128/J256RM3
Responses
There are several types of response tokens. As in the MultiMediaCard mode, all are transmitted MSB first:
⢠Format R1
This response token is sent by the card after every command with the exception of SEND_STATUS
commands. It is one byte long, and the MSB is always set to zero. The other bits are error indications, an
error being signaled by a â1â. The structure of the R1 format is given in Figure âR1 Response Formatâ.
The meaning of the flags is defined as following:
⢠In idle state: The card is in idle state and running the initializing process.
⢠Erase reset: An erase sequence was cleared before executing because an out of erase sequence
command was received.
⢠Illegal command: An illegal command code was detected.
⢠Communication CRC error: The CRC check of the last command failed.
⢠Erase sequence error: An error in the sequence of erase commands occurred.
⢠Address error: A misaligned address, which did not match the block length, was used in the
command.
⢠Parameter error: The commandâs argument (e.g. address, block length) was out of the
allowed range for this card.
7
0
0
in idle state
erase reset
illegal command
com crc error
erase sequence error
address error
parameter error
R1 Response Format
⢠Format R1b
This response token is identical to the R1 format with the optional addition of the busy signal. The busy
signal token can be any number of bytes. A zero value indicates card is busy. A non-zero value indicates
the card is ready for the next command.
Rev.0.02, Sep.15.2004, page 64 of 89
|
▷ |