R0E00008AKCE00EP63 Datasheet, PDF (56/158 Pages) Renesas Technology Corp – Microcomputer Development Environment System

Section 5 Differences between the MCU (H8/38602RF) and the Emulator
Table 5.5 lists the combinations of conditions that can be set in the [Break condition]
dialog box.
Table 5.5 Conditions Set in [Break condition] Dialog Box
Condition
Dialog Box
Address Bus
Condition
Data Condition
[Break condition 1]
O
O
[Break condition 2]
O
X
Note: O: Can be set by checking the radio button in the dialog box.
Read or Write
Condition
O
X
Table 5.6 lists the combinations of conditions that can be set by the BREAKCONDITION_
SET command.
Table 5.6 Conditions Set by BREAKCONDITION_SET Command
Condition
Channel
Address Bus
Condition
(<addropt> option)
Data Condition
(<dataopt> option)
Break condition 1
O
O
Break condition 2
O
X
Note: O: Can be set by the BREAKCONDITION_SET command.
Read or Write
Condition
(<r/wopt> option)
O
X
• Notes on Setting the Break Condition
1. When [Step In], [Step Over], or [Step Out] is selected, the settings of Break Condition are
disabled.
2. The settings of Break Condition are disabled when an instruction to which a
BREAKPOINT has been set is executed.
3. When step over function is used, the settings of BREAKPOINT and Break Condition are
disabled.
4. Do not satisfy Break Condition 2 and another break source (BREAKPOINT or Break
Condition 1) simultaneously. A break will occur with an illegal value.
Rev. 1.00 Aug. 03, 2009 Page 20 of 24
REJ10J2023-0100