H838776 Datasheet, PDF (450/594 Pages) Renesas Technology Corp – 12 Input / 9 Output Video Switch Matrix with Input Clamp, Input Bias Circuitry, and Output Drivers

Section 19 I²C Bus Interface 2 (IIC2)
(2) Transmit Operation
In transmit mode, transmit data is output from SDA, in synchronization with the fall of the transfer
clock. The transfer clock is output when MST in ICCR1 is 1, and is input when MST is 0. For
transmit mode operation timing, refer to figure 19.14. The transmission procedure and operations
in transmit mode are described below.
1. Set the ICE bit in ICCR1 to 1. Set the MST and CKS3 to CKS0 bits in ICCR1 to 1. (Initial
setting)
2. Set the TRS bit in ICCR1 to select the transmit mode. Then, TDRE in ICSR is set.
3. Confirm that TDRE has been set. Then, write the transmit data to ICDRT. The data is
transferred from ICDRT to ICDRS, and TDRE is set automatically. The continuous
transmission is performed by writing data to ICDRT every time TDRE is set. When changing
from transmit mode to receive mode, clear TRS while TDRE is 1.
SCL
SDA
(Output)
TRS
1
2
Bit 0 Bit 1
7
8
1
Bit 6 Bit 7 Bit 0
7
8
Bit 6 Bit 7
1
Bit 0
TDRE
ICDRT
Data 1
Data 2
Data 3
ICDRS
Data 1
User
processing ^{[3] Write data} [3] Write data
to ICDRT _{to ICDRT}
[2] Set TRS
Data 2
Data 3
[3] Write data [3] Write data
to ICDRT
to ICDRT
Figure 19.14 Transmit Mode Operation Timing
Rev. 1.00 Dec. 18, 2006 Page 428 of 568
REJ09B0348-0100