HYB18H1G321AF Datasheet, PDF (18/48 Pages) Qimonda AG – GDDR3 Graphics RAM 1-Gbit GDDR3 Graphics RAM

Internet Data Sheet
HYB18H1G321AF–10/11/14
1-Gbit GDDR3
4.1.1
Burst length
Read and Write accesses to the GDDR3 Graphics RAM are burst oriented with burst length of 4 and 8. This value must be
programmed using the Mode Register Set command (A0 .. A2). The burst length determines the number of column locations
that can be accessed for a given READ or WRITE command.
When a READ or WRITE command is issued, a block of columns equal to the burst length is effectively selected. All accesses
for that burst take place within this block if a boundary is reached. The starting location within this block is determined by the
two least significant bits A0 and A1 which are set internally to the fixed value of zero each.Reserved states should not be used,
as unknown operation or incompatibility with future versions may result.
4.1.2
Burst type
Accesses within a given bank must be programmed to be sequential. This is done using the Mode Register Set command (A3).
This device does not support the burst interleave mode.
Burst Length
4
8
Starting Column Address
A2 A1 A0
—X X
0 XX
1 XX
Order of Accesses within a Burst
(Type = sequential)
0-1-2-3
0-1-2-3-4-5-6-7
4-5-6-7-0-1-2-3
The value applied at the balls A0 and A1 for the column address is “Don’t care”.
TABLE 8
Burst Definition
4.1.3
CAS Latency
The CAS latency is the delay, in clock cycles, between the registration of a READ command and the availability of the first bit
of output data.
If a READ command is registered at clock edge n, and the latency is m clocks, the data will be available nominally coincident
with clock edge n+m.
Reserved states should not be used as unknown operation or incompatibility with future versions may result.
4.1.4
Write Latency
The WRITE latency, WL, is the delay, in clock cycles, between the registration of a WRITE command and the availability of the
first bit of input data.
4.1.5
Test mode
The normal operating mode is selected by issuing a Mode Register Set command with bit A7 set to zero and bits A0-A6 and
A8-A11 set to the desired value.
Rev. 0.92, 2007-10
18
06122007-MW7D-3G3M