MC68HC908GZ16 Datasheet, PDF (198/314 Pages) Motorola, Inc – Microcontrollers

Enhanced Serial Communications Interface (ESCI) Module
15.8 I/O Registers
These I/O registers control and monitor ESCI operation:
• ESCI control register 1, SCC1
• ESCI control register 2, SCC2
• ESCI control register 3, SCC3
• ESCI status register 1, SCS1
• ESCI status register 2, SCS2
• ESCI data register, SCDR
• ESCI baud rate register, SCBR
• ESCI prescaler register, SCPSC
• ESCI arbiter control register, SCIACTL
• ESCI arbiter data register, SCIADAT
15.8.1 ESCI Control Register 1
ESCI control register 1 (SCC1):
• Enables loop mode operation
• Enables the ESCI
• Controls output polarity
• Controls character length
• Controls ESCI wakeup method
• Controls idle character detection
• Enables parity function
• Controls parity type
Address: $0013
Bit 7
6
5
4
3
2
1
Bit 0
Read:
LOOPS ENSCI TXINV
M
WAKE
ILTY
PEN
PTY
Write:
Reset: 0
0
0
0
0
0
0
0
Figure 15-10. ESCI Control Register 1 (SCC1)
LOOPS — Loop Mode Select Bit
This read/write bit enables loop mode operation. In loop mode the RxD pin is disconnected from the
ESCI, and the transmitter output goes into the receiver input. Both the transmitter and the receiver
must be enabled to use loop mode. Reset clears the LOOPS bit.
1 = Loop mode enabled
0 = Normal operation enabled
ENSCI — Enable ESCI Bit
This read/write bit enables the ESCI and the ESCI baud rate generator. Clearing ENSCI sets the SCTE
and TC bits in ESCI status register 1 and disables transmitter interrupts. Reset clears the ENSCI bit.
1 = ESCI enabled
0 = ESCI disabled
MC68HC908GZ16 • MC68HC908GZ8 Data Sheet, Rev. 1
198
Freescale Semiconductor