HAC830CV-M-A-2-A-2 Datasheet, PDF(16/49 Page) Micronas – Robust Multi-Purpose Programmable Linear Hall-Effect Sensor with Integrated Capacitors

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

HAC830CV-M-A-2-A-2 Datasheet, PDF (16/49 Pages) Micronas – Robust Multi-Purpose Programmable Linear Hall-Effect Sensor with Integrated Capacitors

◁

DATA SHEET

HAC 830

Sensitivity

The SENSITIVITY register contains the parameter for the multiplier in the DSP. The

Sensitivity is programmable between ï4 and 4. For VSUP = 5 V, the register can be

changed in steps of 0.00049.

For all calculations, the digital value from the magnetic field of the D/A converter is

used. This digital information is readable from the D/A-READOUT register.

SENSITIVITY

------------ï----V----O----U---T----ï´-----1---6---3---8---3-------------

ï¨ïDA â Readout ï´ VDDï©

ï´

S ens INITIAL

VOQ

The VOQ register contains the parameter for the adder in the DSP. VOQ is the output

signal without external magnetic field (B = 0 mT) and programmable from ïVSUP (ï

100% duty-cycle) up to VSUP (100% duty-cycle). For VSUP = 5 V, the register can be

changed in steps of 4.9 mV (0.05% duty-cycle).

Note: If VOQ is programmed to a negative value, the maximum output signal is limited

to:ï

VOUTmax = VOQ + VSUP

Clamping Levels

The output signal range can be clamped in order to detect failures like shorts to VSUP

or GND or an open circuit.

The CLAMP-LOW register contains the parameter for the lower limit. The lower clamp-

ing limit is programmable between 0 V (min. duty-cycle) and VSUP/2 (50% duty-cycle).

For VSUP = 5 V, the register can be changed in steps of 9.77 mV (0.195% duty-cycle).

The CLAMP-HIGH register contains the parameter for the upper limit. The upper clamp-

ing voltage is programmable between 0 V (min. duty-cycle) and VSUP (max. duty-cycle).

For VSUP = 5 V, in steps of 9.77 mV (0.195% duty-cycle).

Micronas

Feb. 24, 2016; DSH000178_001EN

▷