PIC16F1934_11 Datasheet, PDF (387/472 Pages) Microchip Technology – 28/40/44-Pin Flash-Based, 8-Bit CMOS Microcontrollers

PIC16(L)F1934/6/7
30.3 DC Characteristics: PIC16(L)F1934/6/7-I/E (Power-Down)
PIC16LF1934/36/37
PIC16F1934/36/37
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  TA  +125°C for extended
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  TA  +125°C for extended
Param
No.
Device Characteristics
Min.
Typ†
Max.
+85°C
Max.
+125°C
Units
VDD
Conditions
Note
Power-down Base Current (IPD)⁽²⁾
D023
— 0.06 1.0
8.0
A
1.8 WDT, BOR, FVR, and T1OSC
— 0.08 2.0
9.0
A
3.0 ^{disabled, all Peripherals Inactive}
D023
—
21
55
—
25
58
63
A
1.8 WDT, BOR, FVR, and T1OSC
78
A
3.0 ^{disabled, all Peripherals Inactive}
—
27
60
88
A
5.0
D024
—
0.5
4.0
9.0
A
1.8 LPWDT Current (Note 1)
—
0.8
5.0
10
A
3.0
D024
—
23
57
65
A
1.8 LPWDT Current (Note 1)
—
26
59
80
A
3.0
—
28
61
90
A
5.0
D025
—
15
28
30
A
1.8 FVR current
—
15
30
33
A
3.0
D025
—
38
96
100
A
1.8 FVR current (Note 4)
—
45
110
120
A
3.0
—
90
140
155
A
5.0
D026
—
13
25
28
A
3.0 BOR Current (Note 1)
D026
—
40
110
120
A
3.0 BOR Current (Note 1, Note 4)
—
87
140
155
A
5.0
D027
—
0.6
5.0
9.0
A
1.8 T1OSC Current (Note 1)
—
1.8
7.0
12
A
3.0
D027
—
22
57
60
A
1.8 T1OSC Current (Note 1)
—
29
62
70
A
3.0
—
35
66
85
A
5.0
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Note 1:
The peripheral current is the sum of the base IDD or IPD and the additional current consumed when this peripheral is
enabled. The peripheral  current can be determined by subtracting the base IDD or IPD current from this limit. Max
values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD.
3: A/D oscillator source is FRC.
4: 0.1 F capacitor on VCAP (RA0).
 2008-2011 Microchip Technology Inc.
DS41364E-page 387