PIC18F25K20T-ISS Datasheet, PDF (380/456 Pages) Microchip Technology – 28/40/44-Pin Flash Microcontrollers with nanoWatt XLP Technology

PIC18F2XK20/4XK20
26.10 Memory Programming Requirements
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +125°C
Param
No.
Sym
Characteristic
Min
Typ† Max Units
Conditions
Internal Program Memory
Programming Specifications⁽¹⁾
D110 VPP Voltage on MCLR/VPP/RE3 pin VDD + 4.5 —
9
V (Note 3, Note 4)
D113 IDDP Supply Current during
Programming
—
—
10
mA
Data EEPROM Memory
D120 ED Byte Endurance
100K
—
— E/W -40C to +85C
D121 VDRW VDD for Read/Write
1.8
—
3.6
V Using EECON to
read/write
D122 TDEW Erase/Write Cycle Time
—
4
—
ms
D123 TRETD Characteristic Retention
40
—
— Year Provided no other
specifications are violated
D124 TREF Number of Total Erase/Write
Cycles before Refresh⁽²⁾
1M
10M
— E/W -40°C to +85°C
Program Flash Memory
D130 EP Cell Endurance
10K
—
— E/W -40C to +85C (NOTE 5)
D131 VPR VDD for Read
1.8
—
3.6
V
D132 VIW VDD for Row Erase or Write
2.2
—
3.6
V
D133 TIW Self-timed Write Cycle Time
—
2
—
ms
D134 TRETD Characteristic Retention
40
—
— Year Provided no other
specifications are violated
†
Note 1:
2:
3:
4:
5:
Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
These specifications are for programming the on-chip program memory through the use of table write
instructions.
Refer to Section 7.8 “Using the Data EEPROM” for a more detailed discussion on data EEPROM
endurance.
Required only if single-supply programming is disabled.
The MPLAB ICD 2 does not support variable VPP output. Circuitry to limit the ICD 2 VPP voltage must be
placed between the ICD 2 and target system when programming or debugging with the ICD 2.
Self-write and Block Erase.
DS41303G-page 380
 2010 Microchip Technology Inc.