PIC18F25K20T-ISS Datasheet, PDF (379/456 Pages) Microchip Technology – 28/40/44-Pin Flash Microcontrollers with nanoWatt XLP Technology

PIC18F2XK20/4XK20
26.9 DC Characteristics: Input/Output Characteristics, PIC18F2XK20/4XK20 (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA  +125°C
Param
No.
Symbol
Characteristic
Min
Typ†
Max Units Conditions
VOL Output Low Voltage
D080
I/O ports
—
—
0.6
V IOL = 8.5 mA, VDD
= 3.0V,
-40C to +85C
D083
OSC2/CLKOUT
—
(RC, RCIO, EC, ECIO
modes)
—
0.6
V IOL = 1.6 mA, VDD
= 3.0V,
-40C to +85C
VOH Output High Voltage⁽³⁾
D090
I/O ports
VDD – 0.7
—
—
V IOH = -3.0 mA, VDD
= 3.0V,
-40C to +85C
D092
OSC2/CLKOUT
VDD – 0.7
—
(RC, RCIO, EC, ECIO
modes)
—
V IOH = -1.3 mA, VDD
= 3.0V,
-40C to +85C
Capacitive Loading
Specs
on Output Pins
D100^{(4) COSC2 OSC2 pin}
—
—
15
pF In XT, HS and LP
modes when exter-
nal clock is used to
drive OSC1
D101 CIO All I/O pins and OSC2
—
(in RC mode)
D102 CB
SCL, SDA
—
—
50
pF To meet the AC
Timing
Specifications
—
400
pF I²C™ Specification
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that
the PIC^® device be driven with an external clock while in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: Parameter is characterized but not tested.
 2010 Microchip Technology Inc.
DS41303G-page 379