804-R010-330 Datasheet, PDF (2/32 Pages) Magnetrol International, Inc. – Kotron® Sentinel II Model 804 RF Level Transmitter

Read this Manual Before Installing
This manual provides information on the Kotron Model
804 Sentinel II RF Level Transmitter. It is important that
all instructions are read carefully and followed
in sequence. Detailed instructions are included in the
Installation section of this manual.
Conventions Used in this Manual
Certain conventions are used in this manual to convey
specific types of information. General technical material,
support data, and safety information are presented in
narrative form. The following styles are used for notes,
cautions, and warnings.
Notes
Notes contain information that augments or clarifies
an operating step. Notes do not normally contain
actions. They follow the procedural steps to which
they refer.
Cautions
Cautions alert the technician to special conditions that
could injure personnel, damage equipment, or reduce
a component’s mechanical integrity. Cautions are also
used to alert the technician to unsafe practices or the
need for special protective equipment or specific
materials. In this manual, a caution box indicates a
potentially hazardous situation which, if not avoided,
may result in minor or moderate injury.
Warnings
Warnings identify potentially dangerous situations or
serious hazards. In this manual, a warning indicates an
imminently hazardous situation which, if not avoided,
could result in serious injury or death.
Safety Messages
Follow all standard industry procedures for servicing elec-
trical equipment when working with or around high
voltage. Always shut off the power supply before touching
any components.
Low Voltage Directive
For use in Category II installations. If equipment is used
in a manner not specified by manufacturer, protection
provided by equipment may be impaired.
WARNING! Explosion hazard. Do not connect or dis-
connect equipment unless power has been switched off or
the area is known to be non-hazardous.
Notice of Trademark, Copyright, and Limitations
Magnetrol & Magnetrol logotype, STI & STI logotype,
Kotron, and Sentinel are registered trademarks of
Magnetrol International, Incorporated. Kotron Model
804 Sentinel II RF Level Transmitter is a tradename of
Magnetrol International, Incorporated.
Copyright © 2007 Magnetrol International, Incorporated.
Performance specifications are effective with date of issue
and are subject to change without notice. Magnetrol
makes no warranty with respect to the accuracy of the
information in this manual.
Warranty
All Magnetrol/STI electronic level and flow controls
are warranted free of defects in materials or workmanship
for one full year from the date of original factory
shipment.
If returned within the warranty period; and, upon factory
inspection of the control, the cause of the claim is deter-
mined to be covered under the warranty; then,
Magnetrol/STI will repair or replace the control at no cost to
the purchaser (or owner) other than transportation.
Magnetrol/STI shall not be liable for misapplication,
labor claims, direct or consequential damage or expense
arising from the installation or use of equipment.
There are no other warranties expressed or implied,
except special written warranties covering some
Magnetrol/STI products.
Quality Assurance
The quality assurance system in place at Magnetrol/STI
guarantees the highest level of quality throughout the
company. Magnetrol/STI is committed to providing full
customer satisfaction both in quality products and
quality service.
Magnetrol’s quality assurance system
is registered to ISO 9001 affirming its
commitment to known international
quality standards providing the
strongest assurance of product/service
quality available.