804-R010-330 Datasheet, PDF (16/32 Pages) Magnetrol International, Inc. – Kotron® Sentinel II Model 804 RF Level Transmitter

2.5.5 General Programming Menus
Following is an outline of the general menu
structure used in the Sentinel II. Even though all
features are shown, certain features will only
affect specific modes. For example, the 4–20 mA
output menu can be accessed in all models, but
changes will affect only the models with 4–20 mA
output. Use the UP and DOWN arrow keys to
scroll through any portion of the menu; use the
ENT key to make a selection.
MEASURED VALUES
SYSTEM CONFIG
I/O CONFIG
NOTE: Use
keys to move up or
down in the menu tree.
Use the
key to
accept a value or to
move right in the menu
tree. Use DEL to delete
a keystroke or to move
left in the menu tree.
ADV CONFIG
DIAGNOSTICS
RUN
Level
Loop
Previous Menu
Level Units
Probe Calibrate
Previous Menu
Relay Settings
Select Relay
Lead/Lag Mode
Previous Menu
4–20 mA Settings
Enable/Disable
4 mA Point
20 mA Point
Fault Mode
Previous Menu
Comm Port Setup
Previous Menu
Damping (1–60)
Default Display
Change Password
Adjust Loop Pts
Previous Menu
Test Relays
Test 4–20 Output
Signal Values
View Version #
Factory Presets
Previous Menu
Inches
Feet
Millimeters
Meters
Cal Point #1 (LO)
Cal Point #2 (HI)
Previous Menu
Fault Relay #1 (#1 only)
Relay On SetPt
Relay Off SetPt
Fail-safe (only if Relay On
SetPt = Relay Off SetPt)
Relay On Delay
Relay Off Delay
Fault Mode
Previous Menu
Off
1–2
1–2–3
1–2–3 –4
1–2 & 3–4
} ^{2–3 Only if #1 is}
2–3–4 fault relay.
22 mA
3.5 mA
Hold
Address (0–256)
Baud Rate
Parity
Previous Menu
Level
Loop
Enter Old Password
Enter New Password
Enter New Again
Previous Menu
35 mA offset
22 mA offset
Select Relay
Loop Value
Previous Menu
CCO Int Cap
CCO Open Probe
CCO Probe
Previous Menu
Initialize
Calibrate
Previous Menu
Initialize
Calibrate
Previous Menu
Enable/Disable (#1 only)
DNRG<Set point
DNRG>Set point
DNRG on Fault
Hold on Fault
Off/On
13
50-604 Kotron Model 804 Sentinel II RF Level Transmitter