61312-2 Datasheet, PDF (26/76 Pages) Tyco Electronics – Machine Applied Terminations, Open Barrel Terminals

Machine Applied Terminations, Open Barrel Terminals
(Rings, Spades, Pins, Receptacles, Splices, Tabs)
Splices
Product Facts
I Terminates stranded wire
and/or solid wire
combinations together or to
leads on components or
devices
I End feed splices available
for pigtail connections.
I Side feed splices available
for parallel connections.
I Available in brass, copper-
nickel, phosphor bronze and
steel material
I Precision formed, strip-fed
splices terminated in AMP
automatic machines for high
production rates per hour
Technical Documents
Application Specifications describe
requirements for using the product in its
intended application and/or crimping
information. They are intended for the
Packaging and Design Engineer and the
Machine Setup Person.
114-2088 — Pigtail and Thru Splices
Tyco Electronics offers a full
selection of AMP open
barrel splices that are
specifically designed to
terminate combinations of
stranded wire and/or solid
wire to themselves or to
resistors, light emitting
devices (LED), glass reed
switch assemblies, etc.
Open barrel splices are
available with or without
serrations. Pre-stripped
stranded or solid wire leads
are forced into the serrations
during the crimping process.
The resulting termination
produces a high tensile
strength connection that is
resistant to corrosion.
Depending on your specific
application, open barrel
splices are available for
terminations in the 400 to
30,000 CMA range in brass,
copper-nickel, phosphor
bronze and steel material.
Others are available with
insulation support barrels to
terminate round or square
posts, resistance wire, and
solid pin or calrod leads.
The insulation support
barrel prevents harmful
flexing of the wire at the
termination point where the
wire is rigidly crimped in the
wire barrel and deters
fraying of the insulation.
Depending on your specific
application, open barrel
insulation support splices
are available for
terminations in the 150 to
12,000 CMA range in brass
and steel material.
Insulation piercing splices
are also available to
eliminate the need to
pre-strip the insulated wire.
The barrel contains two
perpendicular lances that
are driven through the wire
insulation to make contact
with the conductor.
Depending on your specific
application, open barrel
insulation piercing splices
are available for terminations
in the 16–22 AWG wire
range in brass material.
Identification splices are
available for wire marking.
Up to three digits can be
stamped on the bands
during the crimping
process. Depending on
your specific application,
open barrel identification
splices are available for
terminations from .150 to
.300 insulation diameters in
brass and aluminum
material.
Open barrel splices are
manufactured in strip form
and supplied on reels for
semi-automated and fully
automated terminations on
crimping machines for high
output per hour production
rates.
26
Catalog 82227
Revised 8-04
www.tycoelectronics.com
Dimensions are in inches and
millimeters unless otherwise
specified. Values in brackets
are metric equivalents.
Dimensions are shown for
reference purposes only.
Specifications subject
to change.
USA: 1-800-522-6752
Canada: 1-905-470-4425
Mexico: 01-800-733-8926
C. America: 52-55-5-729-0425
South America: 55-11-3611-1514
Hong Kong: 852-2735-1628
Japan: 81-44-844-8013
UK: 44-141-810-8967