80C86_06 Datasheet, PDF (6/37 Pages) Intersil Corporation – CMOS 16-Bit Microprocessor

80C86
Maximum Mode System (Continued)
The following pin function descriptions are for the 80C86 system in maximum mode (i.e., MN/MX - GND). Only the pin functions which are
unique to maximum mode are described below.
SYMBOL
PIN
NUMBER
TYPE
DESCRIPTION
RQ/GT0
RQ/GT1
31, 30
I/O
REQUEST/GRANT: pins are used by other local bus masters to force the processor to release
the local bus at the end of the processor’s current bus cycle. Each pin is bidirectional with
RQ/GTO having higher priority than RQ/GT1. RQ/GT has an internal pull-up bus hold device so
it may be left unconnected. The request/grant sequence is as follows (see RQ/GT Sequence
Timing)
1. A pulse of 1 CLK wide from another local bus master indicates a local bus request (“hold”)
to the 80C86 (pulse 1).
2. During a T4 or TI clock cycle, a pulse 1 CLK wide from the 80C86 to the requesting master
(pulse 2) indicates that the 80C86 has allowed the local bus to float and that it will enter the
“grant sequence” state at the next CLK. The CPU’s bus interface unit is disconnected logi-
cally from the local bus during “grant sequence”.
3. A pulse 1 CLK wide from the requesting master indicates to the 80C86 (pulse 3) that the
“hold” request is about to end and that the 80C86 can reclaim the local bus at the next CLK.
The CPU then enters T4 (or TI if no bus cycles pending).
Each Master-Master exchange of the local bus is a sequence of 3 pulses. There must be one
idle CLK cycle after each bus exchange. Pulses are active low.
If the request is made while the CPU is performing a memory cycle, it will release the local
bus during T4 of the cycle when all the following conditions are met:
1. Request occurs on or before T2.
2. Current cycle is not the low byte of a word (on an odd address).
3. Current cycle is not the first acknowledge of an interrupt acknowledge sequence.
4. A locked instruction is not currently executing.
If the local bus is idle when the request is made the two possible events will follow:
1. Local bus will be released during the next cycle.
2. A memory cycle will start within three clocks. Now the four rules for a currently active memory
cycle apply with condition number 1 already satisfied.
LOCK
29
O
LOCK: output indicates that other system bus masters are not to gain control of the system bus
while LOCK is active LOW. The LOCK signal is activated by the “LOCK” prefix instruction and
remains active until the completion of the next instruction. This signal is active LOW, and is held
at a high impedance logic one state during “grant sequence”. In MAX mode, LOCK is automat-
ically generated during T2 of the first INTA cycle and removed during T2 of the second INTA
cycle.
QS1, QSO
24, 25
O
QUEUE STATUS: The queue status is valid during the CLK cycle after which the queue opera-
tion is performed.
QS1 and QS0 provide status to allow external tracking of the internal 80C86 instruction queue.
Note that QS1, QS0 never become high impedance.
QSI QSO
0
0 No Operation
0
1 First byte of op code from queue
1
0 Empty the queue
1
1 Subsequent byte from queue
146