TC1791 Datasheet, PDF (150/153 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC1791
History
• switch input function ECTT1 and ECTT2
• add input function REQ15 to P9.14
• add alternate output O1 for OUT97 of GPTA0
• changed the name for O3 from EVTO2 to EVTO1 for P0.5
• changed the name for O3 from EVTO3 to EVTO2 for P0.6
• changed the name for O3 from EVTO4 to EVTO3 for P0.7
• add input function SLSI2 for SSC2 to P4.9
• change for port 6.15 the symbol from CC61(CCU60) to CC60(CCU61)
• change for port 8.2 the symbol from CC61(CCU60) to COUT63(CCU61)
• add to all SSC signal the assosiated SSC module where is was missing in the pinning
• add section Pin Reliability in Overload
• incease values for absolute maximium parameters I_IN and SumI_IN
• correct P14.8 O2 as this was incorrected label as O1
• add to P4.9 output function OUT1 for LTCA2
The following changes where done between Version 0.63 and 0.7 of this document:
• update value of RTID registers in section Identification Registers for AB step
• remove sentence ‘Exposure to conditions within the maximum ratings will not affect
device reliability. To replace this sentence section Pin Reliability in Overload was
added.
• add footnote 1 to table 12 (Operating Conditions)
• increase values for absolute maximum parameters I_IN and SumI_IN
• remove capacitance conditions for LVDS pad parameters as loads are defined by
interface (MSC) timings
• add parameter V_ILSD for class S pads
• add V_DDM supply limitation for class S parameters
• add footnote 10 to table 23 (ADC parameters)
• remove old footnote 2 from table 24 (FADC parameters)
• remove term typical from load of Peripheral Timings
• add definition of driver strength settings for ERAY Interface Timing
• update formulas for frequency modulation
• change SSC parameter from t₅₉ CC to SR
• change footnote 4 wording for ERAY timing back to TC1797 wording
• increase flash parameters t_PRD and t_PRP values
• increase flash parameter t_ERD
• add section 5.2.6.1.
• change in legende of table 2 definition of class S pad
• correct section Extended Range Operating Conditions for the 3.3 V area
• increase limit in Extended Range Operating Conditions from 1 hour to 1000 hours
• specify wording for limitation of pad performance in section Extended Range
Operating Conditions
• remove incorrect test conditions for RDSONx parameters
• adjust typo in temperature profile
Data Sheet
2
V 1.1, 2014-05