SAK-XE167FM-72F80LAA Datasheet, PDF (104/144 Pages) Infineon Technologies AG – 16-Bit Single-Chip Real Time Signal Controller

XE167FM, XE167GM, XE167HM, XE167KM
XE166 Family / Base Line
Electrical Parameters
3) f_WU in MHz
4) This value includes a hysteresis of approximately 50 mV for rising voltage.
5) V_LV = selected SWD voltage level
6) The limit V_LV - 0.10 V is valid for the OK1 level. The limit for the OK2 level is V_LV - 0.15 V.
Conditions for t_SPO Timing Measurement
The time required for the transition from Power-On to Base mode is called t_SPO. It is
measured under the following conditions:
Precondition: The pad supply is valid, i.e. V_DDPB is above 3.0 V and remains above 3.0 V
even though the XE167xM is starting up. No debugger is attached.
Start condition: Power-on reset is removed (PORST = 1).
End condition: External pin toggle caused by first user instruction executed from FLASH
after startup.
Conditions for t_SSO Timing Measurement
The time required for the transition from Stopover to Stopover Waked-Up mode is
called t_SSO. It is measured under the following conditions:
Precondition: The Stopover mode has been entered using the procedure defined in the
Programmer’s Guide.
Start condition: Pin toggle on ESR pin triggering the startup sequence.
End condition: External pin toggle caused by first user instruction executed from PSRAM
after startup.
Coding of bit fields LEVxV in SWD and PVC Configuration Registers
Table 20
Code
0000_B
0001_B
0010_B
0011_B
0100_B
0101_B
0110_B
0111_B
1000_B
Coding of bit fields LEVxV in Register SWDCON0
Default Voltage Level Notes¹⁾
2.9 V
3.0 V
LEV1V: reset request
3.1 V
3.2 V
3.3 V
3.4 V
3.6 V
4.0 V
4.2 V
Data Sheet
104
V2.1, 2011-07