ICS844S42I Datasheet, PDF (23/27 Pages) Integrated Device Technology – On-chip crystal oscillator for reference frequency generation

ICS844S42I Data Sheet
DUAL OUTPUT RF FREQUENCY SYNTHESIZER
Power Considerations – LVDS Outputs
This section provides information on power dissipation and junction temperature for the ICS844S42I for all outputs that are configured to LVDS
(LEV_SEL = 0). Equations and example calculations are also provided.
1. Power Dissipation.
The total power dissipation for the ICS844S42I is the sum of the core power plus the analog power plus the power dissipated in the load(s).
The following is the power dissipation for V_DD = 3.3V + 5% = 3.465V, which gives worst case results.
The maximum current at 85°C is as follows:
I_{DD_MAX} = 185mA
I_{DDA_MAX} = 22mA
I_{DDO_MAX} = 50mA
• Power (core)_MAX = V_{DD_MAX} * (I_{DD_MAX} + I_{DDA_MAX}) = 3.465V * (185mA + 22mA) = 717.255mW
• Power (output)_MAX = V_{DDO_MAX} * (I_DDOA + I_DDOB) = 3.465V * 50mA = 173.25mW
Total Power__MAX = 717.255mW + 173.25mW = 890.505mW
2. Junction Temperature.
Junction temperature, Tj, is the temperature at the junction of the bond wire and bond pad directly affects the reliability of the device. The
maximum recommended junction temperature is 125°C. Limiting the internal transistor junction temperature, Tj, to 125°C ensures that the bond
wire and bond pad temperature remains below 125°C.
The equation for Tj is as follows: Tj = _JA * Pd_total + T_A
Tj = Junction Temperature
_JA = Junction-to-Ambient Thermal Resistance
Pd_total = Total Device Power Dissipation (example calculation is in section 1 above)
T_A = Ambient Temperature
In order to calculate junction temperature, the appropriate junction-to-ambient thermal resistance _JA must be used. Assuming no air flow and
a multi-layer board, the appropriate value is 31.4°C/W per Table 7B below.
Therefore, Tj for an ambient temperature of 85°C with all outputs switching is:
85°C + 0.891W * 31.4°C/W = 113°C. This is well below the limit of 125°C.
This calculation is only an example. Tj will obviously vary depending on the number of loaded outputs, supply voltage, air flow and the type of
board (multi-layer).
Table 7B. Thermal Resistance _JA for 56 Lead VFQFN, Forced Convection
_JA by Velocity
Meters per Second
0
Multi-Layer PCB, JEDEC Standard Test Boards
31.4°C/W
1
27.5°C/W
2.5
24.6°C/W
ICS844S42BKI REVISION A FEBRUARY 21, 2012
23
©2012 Integrated Device Technology, Inc.