IC42S16160 Datasheet, PDF (21/69 Pages) Integrated Circuit Solution Inc – 4M x 16Bit x 4 Banks (256-MBIT) SDRAM

IC42S16160
Auto Precharge
During a read or write command cycle, A10 controls whether auto precharge is selected. If A10 is high in the read or write
command (Read with Auto precharge command or Write with Auto precharge command), auto precharge is selected and
begins automatically.
In the write cycle, tDAL(min.) must be satisfied before asserting the next activate command to the bank being precharged.
When using auto precharge in the read cycle, knowing when the precharge starts is important because the next activate
command to the bank being precharged cannot be executed until the precharge cycle ends. Once auto precharge has
started, an activate command to the bank can be asserted after tRP has been satisfied.
A Read or Write command without auto - precharge can be terminated in the midst of a burst operation. However, a Read
or Write command with auto - precharge can not be interrupted by the same bank commands before the entire burst opera-
tion is completed. Therefore use of the same bank Read, Write, Precharge or Burst Stop command is prohibited during a
read or write cycle with auto - precharge. It should be noted that the device will not respond to the Auto - Precharge com-
mand if the device is programmed for full page burst read or write cycles.
The timing when the auto precharge cycle begins depends both on both the CAS Iatency programmed into the mode reg-
ister and whether the cycle is read or write.
Read with Auto Precharge
During a READA cycle, the auto precharge begins one clock earlier (CL = 2) or two clocks earlier (CL = 3) than the last word
output.
READ with AUTO PRECHARGE
Burst lengh = 4
T0
T1
T2
T3
T4
T5
T6
T7
T8
CLK
Command
CAS latency = 2
DQ
Command
READA B
No New Command to Bank B
Auto precharge starts
READA B
QB0
QB1
QB2
QB3
No New Command to Bank B
Auto precharge starts
CAS latency = 3
DQ
QB0
QB1
QB2
Remark READA means READ with AUTO PRECHARGE
Hi - Z
QB3 ^{Hi - Z}
Integrated Circuit Solution Inc.
21
DR037-0A 9/05/2003