MB82DBS08164C-70L Datasheet, PDF (18/58 Pages) Fujitsu Component Limited. – 128 M Bit (8 M word×16 bit) Mobile Phone Application Specific Memory

MB82DBS08164C-70L
■ ELECTRICAL CHARACTERISTICS
1. DC Characteristics
Parameter
Symbol
(At recommended operating conditions unless otherwise noted)
Test Conditions
Value
Unit
Min Max
Input Leakage Current
ILI
VSS ≤ VIN ≤ VDD
− 1.0 + 1.0 µA
Output Leakage Current
ILO
0 V ≤ VOUT ≤ VDD,
Output Disable
− 1.0 + 1.0 µA
Output High Voltage Level
VOH VDD = VDD (Min), IOH = − 0.5 mA
1.4
⎯
V
Output Low Voltage Level
VOL IOL = 1 mA
⎯
0.4
V
VDD Power Down Current
IDDPS
IDDP16
IDDP32
IDDP64
VDD = VDD (Max),
VIN = VIH or VIL,
CE2 ≤ 0.2 V
Sleep
⎯
16 M-bit Partial ⎯
32 M-bit Partial ⎯
64 M-bit Partial ⎯
10
µA
130 µA
160 µA
210 µA
VDD = VDD (Max),
IDDS VIN (including CLK) = VIH or VIL,
CE1 = CE2 = VIH
⎯
1.5 mA
VDD Standby Current
IDDS1
VDD = VDD (Max),
VIN (including CLK) ≤ 0.2 V or
VIN (including CLK) ≥ VDD − 0.2 V,
CE1 = CE2 ≥ VDD − 0.2 V
⎯
300 µA
IDDS2
VDD = VDD (Max), tCK = tCK (Min)
VIN ≤ 0.2 V or VIN ≥ VDD − 0.2 V,
CE1 = CE2 ≥ VDD − 0.2 V
⎯
400 µA
VDD Active Current
IDDA1
VDD = VDD (Max),
VIN = VIH or VIL,
tRC/tWC = Min
⎯
CE1 = VIL and CE2 = VIH,
IDDA2 _{IOUT = 0 mA}
tRC/tWC = 1 µs
⎯
40 mA
5
mA
VDD Burst Access Current
IDDA4
VDD = VDD (Max),
VIN = VIH or VIL,
CE1 = VIL and CE2 = VIH,
tCK = tCK (Min), BL = Continuous,
IOUT = 0 mA
⎯
40 mA
Notes : • All voltages are referenced to VSS = 0 V.
• IDD depends on the output termination, load conditions, and AC characteristics.
• After power on, initialization following POWER-UP timing is required. DC characteristics are guaranteed
after the initialization.
18