S9S08SG8E2MTJ Datasheet, PDF (298/320 Pages) Freescale Semiconductor, Inc – MC9S08SG8 MC9S08SG4 Data Sheet Addendum

Appendix A Electrical Characteristics
Table A-7. Supply Current Characteristics (continued)
Num C
Parameter
Temp Rated³
Symbol
V_DD
(V)
Typ¹
Max²
Unit
Standard
AEC
Grade 0
6
C _{RTC adder to stop2 or stop3}⁷
S23I_DDR
5
300
500
nA
x
TI
3
300
500
nA
x
7
C
LVD adder to stop3 (LVDE = LVDSE
= 1)
S3I_DDLVD
5
3
110
90
180
160
A
A
x
x
Adder to stop3 for oscillator
8
C _enabled⁸
(EREFSTEN =1)
x
S3I
5,
DDOS
C
3
5
8
A
x
1 _{Typical values are based on characterization data at 25C. See Figure A-5 through Figure A-7 for typical curves across}
voltage/temperature.
2 _{Max values in this column apply for the full operating temperature range of the device unless otherwise noted.}
3 _{Electrical characteristics only apply to the temperature rated devices marked with x.}
4 _{All modules except ADC active, ICS configured for FBE, and does not include any dc loads on port pins.}
5 _{All modules except ADC active, ICS configured for FEI, and does not include any dc loads on port pins.}
6 _{Stop currents are tested in production for 25C on all parts. Tests at other temperatures depend upon the part number suffix}
and maturity of the product. Freescale may eliminate a test insertion at a particular temperature from the production test flow
once sufficient data has been collected and is approved.
7 _{Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the higher current wait mode.}
8 _{Values given under the following conditions: low range operation (RANGE = 0) with a 32.768kHz crystal and low power mode}
(HGO = 0).
10
FEI
FBELP
8
6
4
2
0
01 2 4
8
f_bus (MHz)
16
20
Figure A-5. Typical Run I_DD vs. Bus Frequency (V_DD = 5V)
MC9S08SG8 MCU Series Data Sheet, Rev. 7
294
Freescale Semiconductor