PXN20 Datasheet, PDF (24/60 Pages) Freescale Semiconductor, Inc – PXN20 Microcontroller

Pin assignments
5 _{The pad type is indicated by one or more of the following abbreviations: A–analog, F—fast speed, H–high voltage, I—input-only,}
M–medium speed, S–slow speed. For example, pad type SH designates a slow high-voltage pad.
6 _{The Status During Reset pin is sampled after the internal POR is negated. Prior to exiting POR, the signal has a high}
impedance. The terminology used in this column is: O – output, I – input, Up – weak pull up enabled, Down – weak pulldown
enabled, Low – output driven low, High – output driven high. A dash on the left side of the slash denotes that both the input and
output buffers for the pin are off. A dash on the right side of the slash denotes that there is no weak pull up/down enabled on
the pin. The signal name to the left or right of the slash indicates the pin is enabled.
7 _{The Function After Reset of a GPI function is general purpose input. A dash on the left side of the slash denotes that both the}
input and output buffers for the pin are off. A dash on the right side of the slash denotes that there is no weak pull up/down
enabled on the pin.
8 _{Pullup is enabled only when JCOMP is negated.}
9 _{Tie to VSS for normal operation.}
PXN20 Microcontroller Data Sheet, Rev. 1
24
Freescale Semiconductor