K11P121M50SF4 Datasheet, PDF (11/59 Pages) Freescale Semiconductor, Inc – K11 Sub-Family Data Sheet

5.2.1 Voltage and current operating requirements
Table 1. Voltage and current operating requirements
Symbol Description
V_DD
Supply voltage
V_DDA Analog supply voltage
V_DD – V_DDA V_DD-to-V_DDA differential voltage
V_SS – V_SSA V_SS-to-V_SSA differential voltage
V_BAT RTC battery supply voltage
V_IH
Input high voltage
• 2.7 V ≤ V_DD ≤ 3.6 V
• 1.7 V ≤ V_DD ≤ 2.7 V
V_IL
Input low voltage
• 2.7 V ≤ V_DD ≤ 3.6 V
• 1.7 V ≤ V_DD ≤ 2.7 V
V_HYS
I_ICIO
Input hysteresis
I/O pin DC injection current — single pin
• V_IN < V_SS-0.3V (Negative current injection)
• V_IN > V_DD+0.3V (Positive current injection)
I_ICcont
Contiguous pin DC injection current —regional limit,
includes sum of negative injection currents or sum of
positive injection currents of 16 contiguous pins
• Negative current injection
• Positive current injection
Min.
1.71
1.71
–0.1
–0.1
1.71
Max.
3.6
3.6
0.1
0.1
3.6
0.7 × V_DD
—
0.75 × V_DD
—
—
—
0.06 × V_DD
0.35 × V_DD
0.3 × V_DD
—
-3
—
—
+3
-25
—
—
+25
Unit
V
V
V
V
V
V
V
V
V
V
mA
mA
V_RAM V_DD voltage required to retain RAM
1.2
—
V
V_RFVBAT V_BAT voltage required to retain the VBAT register file
V_{POR_VBAT}
—
V
General
Notes
1
1. All analog pins are internally clamped to V_SS and V_DD through ESD protection diodes. If V_IN is greater than V_{AIO_MIN}
(=V_SS-0.3V) and V_IN is less than V_{AIO_MAX}(=V_DD+0.3V) is observed, then there is no need to provide current limiting
resistors at the pads. If these limits cannot be observed then a current limiting resistor is required. The negative DC
injection current limiting resistor is calculated as R=(V_{AIO_MIN}-V_IN)/|I_IC|. The positive injection current limiting resistor is
calcualted as R=(V_IN-V_{AIO_MAX})/|I_IC|. Select the larger of these two calculated resistances.
5.2.2 LVD and POR operating requirements
Table 2. V_DD supply LVD and POR operating requirements
Symbol
V_POR
V_LVDH
Description
Falling VDD POR detect voltage
Falling low-voltage detect threshold — high
range (LVDV=01)
Min.
Typ.
Max.
Unit
0.8
1.1
1.5
V
2.48
2.56
2.64
V
Table continues on the next page...
Notes
K11 Sub-Family Data Sheet Data Sheet, Rev. 3, 08/2012.
Freescale Semiconductor, Inc.
11