33899 Datasheet, PDF (1/26 Pages) Freescale Semiconductor, Inc – Programmable H-Bridge Power IC

Freescale Semiconductor
Advance Information
Document Number: MC33899
Rev. 4.0, 10/2009
Programmable H-Bridge
Power IC
The 33899 is designed to drive a DC motor in both forward and
reverse shaft rotation under pulse-width modulation (PWM) control of
speed and torque. A current mirror output provides an analog
feedback signal proportional to the load current. A serial peripheral
interface (SPI) is used to select slew rate control, current
compensation limits and to read diagnostic status (faults) of the H-
Bridge drive circuits. SPI diagnostic reporting includes open circuit,
short-circuit to VIGNP, short-circuit to ground, die temperature range,
and under-voltage on VIGNP.
Features
• Drives inductive loads in a full H-Bridge configuration
• Current mirror output signal (gain selectable via external resistor)
• Short-circuit current limiting
• Thermal shutdown (outputs latched off until reset via the SPI)
• Internal charge pump circuit for the internal high side MOSFETs
• SPI-selectable slew rate control and current limit control
• Over-temperature shutdown
• Outputs can be disabled to high-impedance state
• PWM-able up to 11kHz @ 3.0A
• Synchronous rectification control of the high side MOSFETs
• Low RDS(ON) outputs at high junction temperature (< 165mΩ @
TA = 125°C, VIGNP = 6.0V)
• Outputs survive shorts to -1.0V
• Pb-free packaging designated by suffix code VW
33899
PROGRAMMABLE H-BRIDGE POWER IC
VW SUFFIX (Pb-FREE)
98ASH70693A
30-PIN HSOP
ORDERING INFORMATION
Device
MC33899VW/R2
PC33899CVW
Temperature
Range (T_A)
-40°C to 125°C
Package
30 HSOP
V_{DDL +5.0 V} V_IGNP
MCU
33899
VIGNP
VCC
VDDQ
CSNS
REDIS
CRES
VCCL
FWD
REV
S1
PWM
EN1
S0
EN2
CS
RS
SCLK
D1
D0
LSCMP
GND
Figure 1. 33899 Simplified Application Diagram
This document contains certain information on a new product.
Specifications and information herein are subject to change without notice.
© Freescale Semiconductor, Inc., 2007-2009. All rights reserved.