English
Language : 

FIN24C_06 Datasheet, PDF (14/25 Pages) Fairchild Semiconductor – uSerDes™Low-Voltage 24-Bit Bi-Directional Serializer/Deserializer
DC Electrical Characteristics
Values are provided for over-supply voltage and operating temperature ranges, unless otherwise specified.
Symbol
Parameter
Test Conditions
Min.
Typ.(2)
Max. Unit
LVCMOS I/O
VIH Input High Voltage
VIL Input Low Voltage
VOH Output High Voltage
VOL Output Low Voltage
IIN Input Current
DIFFERENTIAL I/O
IOH = –2.0 mA VDDP = 3.3 ± 0.3
VDDP = 2.5 ± 0.2
VDDP = 1.8 ± 0.15
IOL = 2.0 mA VDDP = 3.3 ± 0.3
VDDP = 2.5 ± 0.2
VDDP = 1.8 ± 0.15
VIN = 0V to 3.6V
0.65 x VDDP
GND
0.75 x VDDP
–5.0
VDDP
V
0.35 x VDDP V
V
0.25 x VDDP V
5.0
µA
IODH Output High Source
Current
VOS = 1.0V, Figure 14
1.75
mA
IODL Output Low Sink Current
IOZ Disabled Output Leakage
Current
VOS = 1.0V, Figure 14
CKSO, DSO = 0V to VDDS,
S2 = S1 = 0V
0.95
mA
±0.1
±5.0
µA
IIZ Disabled Input Leakage
Current
CKSI, DSI = 0V to VDDS,
S2 = S1 = 0V
±0.1
±5.0
µA
VICM
VGO
Input Common Mode Range VDDS = 2.775 ± 5%
Input Voltage Ground
See Figure 15
Off-set Relative to Driver(3)
VGO + 0.80
V
0
V
RTRM CKSI Internal Receiver
VID = 50mV, VIC = 925mV, DIRI =
80.0
100
120
¾
Termination Resistor
0,
| CKSI+ – CKSI- | = VID
RTRM DSI Internal Receiver,
VID = 50mV, VIC = 925mV, DIRI =
80.0
100
120
¾
Termination Resistor
0,
| DSI+ – DSI- | = VID
Notes:
2. Typical Values are given for VDD = 2.775V and TA = 25°C. Positive current values refer to the current flowing into device
and negative values means current flowing out of pins. Voltage is referenced to GROUND unless otherwise specified
(except ΔVOD and VOD).
3. VGO is the difference in device ground levels between the CTL driver and the CTL receiver.
©2005 Fairchild Semiconductor Corporation
FIN24C Rev. 1.0.2
14
www.fairchildsemi.com