XR17V254 Datasheet, PDF (54/70 Pages) Exar Corporation – 66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT

XR17V254
66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT
REV. 1.0.0
EFR[6]: Auto RTS or DTR Flow Control Enable
RTS#/DTR# output may be used for hardware flow control by setting EFR bit [6] to logic 1. When Auto RTS/
DTR is selected, an interrupt will be generated when the receive FIFO is filled to the programmed trigger level
and RTS/DTR# will de-assert (HIGH) at the next upper trigger or selected hysteresis level. RTS/DTR# will re-
assert (LOW) when FIFO data falls below the next lower trigger or selected hysteresis level (see FCTR bits 4-
7). The RTS# or DTR# output must be asserted (LOW) before the auto RTS/DTR can take effect. The selection
for RTS# or DTR# is through MCR bit [2]. RTS/DTR# pin will function as a general purpose output when
hardware flow control is disabled.
• Logic 0 = Automatic RTS/DTR flow control is disabled (default).
• Logic 1 = Enable Automatic RTS/DTR flow control.
EFR[5]: Special Character Detect Enable
• Logic 0 = Special Character Detect Disabled (default).
• Logic 1 = Special Character Detect Enabled. The UART compares each incoming receive character with
data in Xoff-2 register. If a match exists, the received data will be transferred to FIFO and ISR bit [4] will be
set to indicate detection of the special character. bit [0] corresponds with the LSB bit for the receive
character. If flow control is set for comparing Xon1, Xoff1 (EFR [1:0]=10) then flow control and special
character work normally. However, if flow control is set for comparing Xon2, Xoff2 (EFR[1:0]=01) then flow
control works normally, but Xoff2 will not go to the FIFO, and will generate an Xoff interrupt and a special
character interrupt.
EFR[4]: Enhanced Function Bits Enable
Enhanced function control bit. This bit enables the enhanced functions in IER bits [7:5], ISR bits [5:4], FCR
bits [5:4], MCR bits [7:5,3:2] and MSR [7:2] bits to be modified. After modifying any enhanced bits, EFR bit [4]
can be set to a logic 0 to latch the new values. This feature prevents legacy software from altering or
overwriting the enhanced functions once set. Normally, it is recommended to leave it enabled, HIGH.
• Logic 0 = modification disable/latch enhanced features. IER bits [7:5], ISR bits [5:4], FCR bits [5:4], MCR
bits [7:5, 3:2] and MSR [7:2] bits are saved to retain the user settings. After a reset, all these bits are set to a
logic 0 to be compatible with ST16C550 mode (default).
• Logic 1 = Enables the enhanced functions. When this bit is set to a logic 1 all enhanced features are
enabled.
54