XR17V254 Datasheet, PDF (25/70 Pages) Exar Corporation – 66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT

REV. 1.0.0
XR17V254
66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT
MPIOLVL Register
Multipurpose Output Level Control
Bit-7 Bit-6 Bit-5 Bit-4 Bit-3 Bit-2 Bit-1 Bit-0
MPIO7 MPIO6 MPIO5 MPIO4 MPIO3 MPIO2 MPIO1 MPIO0
MPIO3T [7:0] (default 0x00)
Output pin tri-state control. A logic 0 (default) sets the output to active level per register MPIOBIT settling, a
logic 1 sets the output pin to tri-state.
MPIO3T Register
Multipurpose Output 3-state Enable
Bit-7 Bit-6 Bit-5 Bit-4 Bit-3 Bit-2 Bit-1 Bit-0
MPIO7 MPIO6 MPIO5 MPIO4 MPIO3 MPIO2 MPIO1 MPIO0
MPIOINV [7:0] (default 0x00)
Input inversion control. A logic 0 (default) does not invert the input pin logic. A logic 1 inverts the input logic
level.
MPIOINV Register
Multipurpose Input Signal Inversion Enable
Bit-7 Bit-6 Bit-5 Bit-4 Bit-3 Bit-2 Bit-1 Bit-0
MPIO7 MPIO6 MPIO5 MPIO4 MPIO3 MPIO2 MPIO1 MPIO0
MPIOSEL [7:0] (default 0xFF)
Multipurpose input/output pin select. This register defines the functions of the pins. A logic 1 (default) defines
the pin for input and a logic 0 for output.
MPIOSEL Register
Multipurpose Input/Output Selection
Bit-7 Bit-6 Bit-5 Bit-4 Bit-3 Bit-2 Bit-1 Bit-0
MPIO7 MPIO6 MPIO5 MPIO4 MPIO3 MPIO2 MPIO1 MPIO0
2.0 CRYSTAL OSCILLATOR / BUFFER
The V254 includes an on-chip oscillator (XTAL1 and XTAL2). The crystal oscillator provides the system clock
to the Baud Rate Generators (BRG) in each of the 4 UARTs, the 16-bit general purpose timer/counter and
internal logics. XTAL1 is the input to the oscillator or external clock buffer input with XTAL2 pin being the
output. See the Programmable Baud Rate Generator in the UART section on page 29 for programming details.
The on-chip oscillator is designed to use an industry standard microprocessor crystal (parallel resonant with
10-22 pF capacitance load, 100ppm) connected externally between the XTAL1 and XTAL2 pins (see
Figure 10). Alternatively, an external clock can be connected to the XTAL1 pin to clock the internal 4 baud rate
25