XR21B1422IL40-0A Datasheet, PDF (25/60 Pages) Exar Corporation – Enhanced 2-Ch Full-Speed USB UART

XR21B1422
Bit
7:0
Default
Description
0x11
XON Character
In Automatic Software Flow control mode, the UART will suspend data transmission when the XON character has been
received. For behavior in the address match mode, see “Multidrop mode with address matching” on page 17.
XOFF_CHAR (0x008) - Read/Write
The XOFF_CHAR stores the 5 through 8 bit XOFF character that is used for Automatic Software Flow control. In 9 bit mode,
only bits 7 through 0 are used, i.e. bit 8 is always a ’0.’ Alternately, this register holds the multicast address for multi-drop
applications with address matching mode.
Bit
15:8
7:0
Default
Description
0
0x13
Reserved
These bits are reserved and should be written as ‘0’.
XOFF Character
In Automatic Software Flow control mode, the UART will suspend data transmission when the XOFF character has been
received. For behavior in the address match mode, see “Multidrop mode with address matching” on page 17.
ERROR_STATUS (0x009) - Read-Clear
This register reports any historical framing, parity and overrun errors as well as both current and historical break status,
since the last time this register was read. As such, it does not indicate which character(s) the error(s) were associated with.
For diagnostic purposes, WIDE_MODE may be enabled such that errors are directly associated with the current byte.
Bit
15:8
7
6
5
4
3
2:0
Default
Description
0
Reserved
These bits are reserved and should be written as ‘0’.
0
Break Status (Read-Only)
0: Break condition is not present.
1: Break condition is currently being detected.
0
Overrun Error
0: No overrun error.
1: An overrun error has been detected (clears after read). An overrun error occurs when the RX FIFO is full and another byte
of data is received.
0
Parity Error
0: No parity error.
1: A parity error has been detected (clears after read).
0
Framing Error
0: No framing error.
1: A framing error has been detected (clears after read). A framing error occurs when a stop bit is not present when it is
expected.
0
Break Error
0: No break condition.
1: A break condition has been detected (clears after read).
0
Reserved
These bits are reserved and should be written as ‘0’.
© 2014 Exar Corporation
25 / 60
exar.com/XR21B1422
Rev 1A