XR20M1172G28-0B Datasheet, PDF (19/55 Pages) Exar Corporation – TWO CHANNEL I2C/SPI UART WITH 64-BYTE FIFO

XR20M1172
REV. 1.2.0
TWO CHANNEL I2C/SPI UART WITH 64-BYTE FIFO
the stop bit of the character in process is shifted out. Transmission is resumed after the CTS# input is re-
asserted (LOW), indicating more data may be sent.
FIGURE 17. AUTO RTS AND CTS FLOW CONTROL OPERATION
Local UART
UARTA
Receiver FIFO
RXA
Trigger Reached
Remote UART
UARTB
TXB
Transmitter
Auto RTS
Trigger Level
Transmitter
RTSA#
TXA
CTSB#
RXB
Auto CTS
Monitor
Receiver FIFO
Trigger Reached
Auto CTS
Monitor
CTSA#
RTSB#
Auto RTS
Trigger Level
RTSA#
CTSB#
TXB
Assert RTS# to Begin
Transmission
1
ON
2
ON
3
Data Starts
4
RXA FIFO
Receive
INTA
Data
RX FIFO
Trigger Level
5
(RXA FIFO
Interrupt)
OFF
7
8 ^OFF
10 ON
11
ON
6 _Suspend
Restart
9
RTS High
Threshold
RTS Low
Threshold
RX FIFO
12 _{Trigger Level}
RTSCTS1
The local UART (UARTA) starts data transfer by asserting RTSA# (1). RTSA# is normally connected to CTSB# (2) of
remote UART (UARTB). CTSB# allows its transmitter to send data (3). TXB data arrives and fills UARTA receive FIFO
(4). When RXA data fills up to its receive FIFO trigger level, UARTA activates its RXA data ready interrupt (5) and con-
tinues to receive and put data into its FIFO. If interrupt service latency is long and data is not being unloaded, UARTA
monitors its receive data fill level to match the upper threshold of RTS delay and de-assert RTSA# (6). CTSB# follows
(7) and request UARTB transmitter to suspend data transfer. UARTB stops or finishes sending the data bits in its trans-
mit shift register (8). When receive FIFO data in UARTA is unloaded to match the lower threshold of RTS delay (9),
UARTA re-asserts RTSA# (10), CTSB# recognizes the change (11) and restarts its transmitter and data flow again until
next receive FIFO trigger (12). This same event applies to the reverse direction when UARTA sends data to UARTB
with RTSB# and CTSA# controlling the data flow.
19