AP9319 Datasheet, PDF (7/30 Pages) List of Unclassifed Manufacturers – Environmental Monitoring Unit

Overview
Front panel
Rear panel
The front panel of the Environmental Monitoring Unit has a RS232
console port that connects the unit to a local computer, using the
configuration cable (940-0103). Through the serial connection, you can
access all setup, status, maintenance, and diagnostic information for the
unit.
10/100Base-T
10/100 Status
Power
Reset
10 = Green
100 = Orange
User Contact Inputs
1 2 34
Temperature/
Humidity
Probe 1 Probe 2
Alarm
Beacon
Output
Item
Function
 Power inlet
Connection to universal power supply.
 Reset Button
Reset the unit. This will not affect the operation of
any connected devices.
 10/100
10/100 LEDs: indicate traffic on the network
(green: operating at 10 mbps; orange: operating at
100 mbps).
 Status LED
Indicate the status of the network connection (solid
green: an IP has been established; blinking green:
attempting to obtain an IP).
 User Contact Input Provide four user input connections for connecting
Connections
normally open or normally closed input contacts.
 Local Temperature
and Humidity
Probe Connections
Connect up to two local temperature/humidity
probes (AP9512TBLK or AP9512THBLK).
 ^{A-Link Ports}
APC device protocol used to communicate to
temperature/humidity probes (AP9520T or
AP9520TH) and air distribution products.
 Alarm Beacon Port Connect to the rack beacon.
 Output Relay
Connect to relay controlled external devices. (See
“Connector pinout descriptions” on page 4.)
Environmental Monitoring Unit — Installation and Quick Start
3