AP9319 Datasheet, PDF (15/30 Pages) List of Unclassifed Manufacturers – Environmental Monitoring Unit

Quick Configuration
Overview
TCP/IP configuration
methods
Warning
Disregard the procedures in this section if you have APC
InfraStruXure Manager as part of your system. See the
InfraStruXure Manager’s documentation for more
information.
You must configure the following TCP/IP settings before the
Environmental Monitoring Unit can operate on a network:
• IP address of the unit
• Subnet mask
• Default gateway
If a default gateway is unavailable, use the IP address
of a computer that is located on the same subnet as the
Note ^{unit and that is usually running. The unit uses the}
default gateway to test the network when traffic is
very light. See “Watchdog Features” in the
“Introduction” of the Environmental Monitoring Unit
User’s Guide for more information about the
watchdog role of the default gateway.
Use one of the following methods to define the TCP/IP settings needed
by the unit:
• Device IP Configuration Wizard (See “Device IP Configuration
Wizard” on page 12.)
• BOOTP or DHCP server (See “BOOTP & DHCP configuration”
on page 12.)
• Local computer (See “Local access to the control console” on
page 15.)
• Networked computer (See “Remote access to the control console”
on page 15.)
Environmental Monitoring Unit — Installation and Quick Start
11