RFM95 Datasheet, PDF (53/121 Pages) List of Unclassifed Manufacturers – Low Power Long Range Transceiver Module

WIRELESS & SENSING
RFM95/96/97/98(W)
PRELIMINARY
DATASHEET
4.2.5.6. Receiver Hopping, Rx to Rx
Two methods are possible:
First method
0
Timeline
TS_HOP
+TS_RE
Rx Mode,
Channel A
1. set new Frf
2. set RestartRxWithPllLock
Rx Mode,
Channel B
Second method
0
Timeline
~TS_HOP
Rx Mode,
Channel A
1. set FastHopOn=1
2. set new Frf (*)
3. wait for TS_HOP
Rx Mode,
Channel B
(*) RegFrfLsb must be written to
trigger a frequency change
Figure 21. Receiver Hopping
The second method is quicker, and should be used if a very quick RF sniffing mechanism is to be implemented.
4.2.5.7. Tx to Tx
0
~PaRamp
+TS_HOP
Tx Mode,
Channel A
1. set new Frf (*)
2. set FSTx mode
FSTx
Timeline
~PaRamp
+TS_HOP
+TS_TR
Set Tx mode
Tx Mode,
Channel B
Figure 22. Transmitter Hopping
4.2.6. Receiver Startup Options
The RFM95/96/97/98(W) receiver can automatically control the gain of the receive chain (AGC) and adjust the
receiver LO
frequency (AFC). Those processes are carried out on a packet-by-packet basis. They occur:
Š When the receiver is turned On.
Š When the Receiver is restarted upon user request, through the use of trigger bits RestartRxWithoutPllLock or
RestartRxWithPllLock, in RegRxConfig.
Š When the receiver is automatically restarted after the reception of a valid packet, or after a packet collision.
Page 53
Tel: [phone] Fax: [phone] E-mail: [e-mail] http:/ / www.hoperf.com