 English |
|
|
|
|
|
|
|
| EVAL-BF5XX Datasheet, PDF (24/35 Pages) List of Unclassifed Manufacturers – Bluetechnix Mechatronische Systeme GmbH | |||
| |||
| ◁ |
On
Off
12345678
Due to the limited number of pins on the two connectors, the CM-BF561 can only set its boot mode on the core
module itself by changing the resistor settings. See the CM-BF561 manual for further details.
Boot-settings for TCM-BF518 (S2) only Switches 1 â 3 are shown
Switch Settings
BMODE0,BMODE1,BMODE2
On
Off
12345678
On
Off
12345678
On
Off
12345678
On
Off
12345678
On
Off
12345678
On
Off
12345678
On
Off
12345678
On
Off
12345678
Boot Mode Description
0
Idle â No boot
1
Boot from 8Bit or 16Bit EEPROM/Flash
(Standard boot mode for BLACKSheep, uBoot and
uClinux)
2
Boot from internal SPI memory
3
Boot from external SPI memory (EEPROM or flash)
4
Boot from SPI Host
5
Boot from OTP memory
6
Boot from SDRAM
7
Boot from UART0
Table 6-4: Boot Mode TCM-BF518 Type
7 Using a Core Module with on board USB
If you use a Core Module with USB feature, for example the CM-BF527 set switch 4 of S2 to âonâ. This connects the
5.0V pin of the USB connector X9 to pin 53 of the Core Module.
If you do not use a Core Module with on board USB feature the switch 4 of S2 should always remain âoffâ.
8 Installation
8.1 Initial Board Setup
The installation guide is written for Windows (Windows 2000 and WinXP). However for connecting the USB
device the drivers for MAC and LINUX are available on the CD.
In order to set up und test the board the follow the next steps:
DEV-BF5xxDA-lite V5.x Hardware User Manual
23
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese