EVAL-BF5XX Datasheet, PDF (20/35 Pages) List of Unclassifed Manufacturers – Bluetechnix Mechatronische Systeme GmbH

5 Switches, Jumper and LED Description
5.1 S1 Ethernet Switch for the CM-BF527and the CM-BF537E
This 8 pin DIP switch enables the Ethernet connector. It is necessary to switch them on for the Core Modules CM-
BF527 and CM-BF537E and off for all others.
Switch Settings
On
Off
12345678
On
Off
12345678
Description
CM-BF527, CM-BF537E
CM-BF533, CM-BF537U, TCM-BF537, CM-BF561, TCM-BF518
Table 5-1: Ethernet Switch
5.2 S2 Core Module Configuration
5.2.1 SD-Card CS and USB VBUS
Switch Settings S2 (only 5-8 shown)
CM-BF527
CM-BF533 and CM-BF561
Core Module inserted
On
Off
12345678
On
Off
12345678
CM-BF537U
CM-BF537E and TCM-BF537
TCM-BF518
On
Off
12345678
On
Off
12345678
On
Off
12345678
Table 5-2: Core Module Configuration (1-3 are for Boot Mode only)
For switch settings 1-3 please refer to chapter 6 “Boot Mode Description”.
5.2.2 CAN
Switch Settings S2 (only 7-8 shown)
CAN enable (ADSP-BF537 only)
CAN disable
Table 5-3: CAN disable
Core Module inserted
On
Off
12345678
On
Off
12345678
5.3 S4 – UART Switch
Move S4 to position 0 to route the Core Modules RX and TX signals to USB
DEV-BF5xxDA-lite V5.x Hardware User Manual
19