EVAL-BF5XX Datasheet, PDF (21/35 Pages) List of Unclassifed Manufacturers – Bluetechnix Mechatronische Systeme GmbH

Move S4 to position 1 to route the Core Modules RX and TX signals to X5
5.4 JP1 - Power Supply Jumper
This jumper can be removed in order to insert an AMPERE METER for current measurement of the entire Core
Module.
5.5 JP2 – RTC Power Jumper
This jumper is used to connect the VddRTC pin of the Core Module to 3.3V. You can also use this jumper to connect
a battery (Vcc) to the internal RTC of the Blackfin. For connecting GND use pin 3 of the UART expansion pads.
5.6 JP3
For the CM-BF527 JP3 is used to connect the USB-ID pin to the Core Module. For all other Core Modules, leave it
open!
5.7 JP6 USB-ID
For the CM-BF527 JP6 is used to force the USB-OTG master mode. For all other Core modules leave it open!
5.8 Buttons S3, S6
The Button S3 is the main Reset Button of the Core Module.
The Button S6 is a general-purpose input button on pin 18 of the Core Module.
Core Module
CM-BF527
CM-BF533
CM-BF537E
CM-BF537U
CM-BF561
TCM-BF537
TCM-BF518
Button S6
PF14
PF5
PG14
PG14
PF46
PG14
PF14
Table 5-4: Pin assignment of button S6
5.9 General Purpose LEDs
The LED V14 indicates that the board is powered.
The LED’s V9 and V10 are connected to general-purpose IO pins 45 and 16 respectively.
Core Module
CM-BF527
CM-BF533
CM-BF537E
CM-BF537U
CM-BF561
TCM-BF537
TCM-BF518
LED V9
PF11
PF8
PG11
PG11
PF43
PG11
PF11
LED V10
PF10
PF9
PG10
PG10
PF42
PG10
PF10
Table 5-5: Core Module LEDs
5.10 Ethernet LEDs
Designator
V1
V2
Color
Yellow
Green
Function
Full Duplex
Activity
DEV-BF5xxDA-lite V5.x Hardware User Manual
20