GD25Q128C Datasheet, PDF (8/69 Pages) ELM Electronics – 128M-bit Serial Flash

GD25Q128CxIGx 3.3V Uniform Sector Dual and Quad Serial Flash
http://www.elm-tech.com
Figure 1. Hold Condition
CS#
SCLK
HOLD#
HOLD
HOLD
RESET
The RESET# pin allows the device to be reset by the control. For the WSON8 package, the pin7 can be
configured as a RESET# pin depending on the status register setting, which need QE=0 and HOLD/RST=1. On
the SOP16 package, a dedicated RESET# pin is provided and it is independent of QE bit setting.
The RESET# pin goes low for a period of tRLRH or longer will reset the flash. After reset cycle, the flash is at
the following states:
- Standby mode
- All the volatile bits will return to the default status as power on.
Figure 2. RESET Condition
CS#
RESET#
RESET
69 - 8
Rev.1.2