GD25Q128C Datasheet, PDF (4/69 Pages) ELM Electronics – 128M-bit Serial Flash

GD25Q128CxIGx 3.3V Uniform Sector Dual and Quad Serial Flash
1. FEATURES
http://www.elm-tech.com
♦ 128M-bit Serial Flash
♦ Program/Erase Speed
- 16384K-byte
- 256 bytes per programmable page
♦ Standard, Dual, Quad SPI
- Standard SPI: SCLK, CS#, SI, SO, WP#, HOLD#/RESET#
- Dual SPI: SCLK, CS#, IO0, IO1, WP#, HOLD#/RESET#
- Quad SPI: SCLK, CS#, IO0, IO1, IO2, IO3
- QPI: SCLK, CS#, IO0, IO1, IO2, IO3
- Page Program time: 0.6ms typical
- Sector Erase time: 50ms typical
- Block Erase time: 0.2/0.3s typical
- Chip Erase time: 60s typical
♦ Flexible Architecture
- Sector of 4K-byte
- Block of 32/64K-byte
♦ High Speed Clock Frequency
♦ Low Power Consumption
- 104MHz for Standard and Dual SPI fast read with 30PF load - 20mA maximum active current
- 80MHz for Quad SPI and QPI fast read with 30PF load - 5μA maximum power down current
- Dual I/O Data transfer up to 208Mbits/s
- Quad I/O Data transfer up to 320Mbits/s
- QPI Mode Data transfer up to 320Mbits/s
- Continuous Read With 8/16/32/64-byte Wrap
♦ Advanced Security Features⁽¹⁾
- 3×512-Byte Security Registers With OTP Locks
- Discoverable parameters(SFDP) register
♦ Software/Hardware Write Protection
♦ Single Power Supply Voltage
- Write protect all/portion of memory via software
- Full voltage range: 2.7~3.6V
- Enable/Disable protection with WP# pin
- Top or Bottom, Sector or Block selection
♦ Cycling endurance
♦ Package Information
- SOP8 (208mil)
- WSON8 (6×5mm)
- Minimum 100,000 Program/Erase Cycles
♦ Data retention
- 20-year data retention typical.
Note: (1) Please contact ELM for details.
69 - 4
Rev.1.2